Cost of Transcription is typically based upon several modalities of measurement which may include the number of reports, minutes, and/or lines produced. Understanding the measurements used in calculating the cost is the key.
PAGE: The definition is self-explanatory. Each page of finished transcription counts as a billing unit. Variables that affect billing by the page include margins, font selections, and justification. In addition, a problem arises where one page may have a few lines on it while another one could be completely full. This result in poor correlation between the amount of transcription produced and the amount billed.
REPORT: The definition is self-explanatory. The total pages contained in one report of finished transcription counts as one billing unit. Variables that affect billing by report include margins, font selections, and justification. While the charge is a flat rate, the result is a poor correlation between the amount of transcription produced and the amount billed.
MINUTE: The definition is every minute that the dictator spends dictating is a billing unit. While in theory this seems like a great idea because a minute of dictation is easy to define, there are a couple of problems that result from this. Different dictation systems produce different dictation times for the same dictation. This is because of the start and stop timers begin and end in different places on different dictation systems. Lastly, because authors dictate at different speeds, the same amount of dictation can produce very different amounts of transcription. All too often, dictators are interrupted while recording, conversing with co-workers, increasing the dictation time.
GROSS LINES: Gross lines are also known as "visual line count". Every line on a page that has text counts as a "line" and every blank line (typically, but no always) does not. Variables that affect gross lines include font sizes, character styles, margin widths, justification, and format. Most people tend to like counting by the gross line because of its relative simplicity. However, there is no reliable method for directly comparing different gross line counts between reports that do not use the same fonts and margin widths. Gross lines are directly related to the type of formatting that is done. If an MT uses a lot of indents or tabs in formatting the report, the gross line count will go up without a corresponding increase in the number of characters typed (savvy MT’s know how to "goose" their line counts by formatting this way). Also, sometimes gross line counts include "blank" lines (although most commonly it is assumed that blank lines are not included).
CHARACTER LINES: A character line usually consists of adding up the number of characters you physically see on a printed page and then dividing the total character count by some quantity, 45, 50, 55, 60, or 65. Most of the time spaces (spacebar) are counted as a character as well as carriage returns.
Years ago, the American Association for Medical Transcription defined a line as "any letter, number, symbol, or function key necessary for the final appearance and content of a document." This definition created a world wind of variation by many vendors, looking for ways to count every single keystroke generated by the MT, including keystrokes to run macros, spell check, and open up word processing programs. AAMT has since changed it's endorsement of the type of line and maintains that it is just a "recommendation." Character lines as a method of measure continue to be a better measurement of productivity as long as it is verifiable, definable, consistent, and is a fair and honest representation of the charge for services rendered.
Click here for the latest press release from AAMT